JohnOblak.com Web Development Laboratory |
Chip Carving Lap Desk - Top |
||||||||||||||||||||||||
Chip Carving Lap Desk - Top HOLES - To allow the chips to fall into the lap desk, I drilled six 1" diameter holes, spaced 1 1/2" on center, centered 3" up from the front edge. To keep from damaging the plywood, I ran a 1" Forstner bit into one side until the tip showed through, and then used the small hole to align the bit as I drilled in from the other side. Round-over the hole edges with a 1/4" round-over bit. Be careful that the bearing meets the work half way down the hole. |
||||||||||||||||||||||||
|
Home | Webmaster |